If you had a difficulty in setting up of an IDA Electrode into a connector at the cable, loosening the four grippers of the connector (shown in Figure below) with a tweezer would work.

Figure in right shows wire assembly of connecting cable.

In order to avoid abrasion on a connector part of the electrode, please insert and remove it according to the following order:

[IDA Electrode Setup Sequence]

(1)Put the IDA electrode into the connector
(2)Insert the white color electrode fixer into the connector

Click

[IDA Electrode Remove Sequence]

(1)Remove the white color electrode fixer from the connector
(2)Remove the IDA electrode from the connector

Click